Physics, 29.06.2019 04:10 staffordkimberly

Amagnesium alloy bar 6 in. in diameter is being turned on a lathe at a depth of cut d = 0.050 in. the lathe is equipped with a 10-hp electric motor and has a mechanical efficiency of 80%. the spindle speed is 500 rpm. estimate the maximum feed that can be used before the lathe begins to stall.(0.45 w-s/mm^3 value of specific power for magnesium alloy)

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:40, naomicervero

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

Answers: 1

continue

Physics, 22.06.2019 14:30, darceline1574

Alandscaper is shopping for landscaping materials. she wants to use materials through which water flows easily. which materials should she choose? check all that apply. clay gravel granite rocks with cracks loosely packed soil

Answers: 2

continue

Physics, 22.06.2019 14:40, sherlinejules1

You throw a small rock straight up from the edge of a highway bridge that crosses a river. the rock passes you on its way down, 7.00 s after it was thrown. what is the speed of the rock just before it reaches the water 28.0 m below the point where the rock left your hand? ignore air resistance.

Answers: 2

continue

Physics, 22.06.2019 15:30, 573589

The radius of a sphere is increasing at a rate of 9 cm/ sec. find the radius of the sphere when the volume and the radius of the sphere are increasing at the same numerical rate.

Answers: 1

continue

You know the right answer?

Amagnesium alloy bar 6 in. in diameter is being turned on a lathe at a depth of cut d = 0.050 in. th...