Select all the correct definitions
a. mechanical advantage is the ratio of output force/ input force
b. mechanical advantage is the ratio of input/output force
c. efficiency is the ratio of input work/ output work expressed as a percentage
d. efficiency is the ratio of output work/input work expressed as a percentage

What is the relationship between atmospheric pressure and the density of gas particles in an area of increasing pressure? (2 points) as air pressure in an area increases, the density of the gas particles in that area decreases. as air pressure in an area increases, the density of the gas particles in that area increases. as air pressure in an area increases, the density of the gas particles in that area remains constant. as air pressure in an area increases, the density of the gas particles in that area increases and decreases in an alternating pattern. 3. which of the following correctly describes a way in which earth's atmosphere interacts with the geosphere? (2 points) it contains gases that living organisms breathe. it contains gases that trap incoming solar radiation. it provides a medium for cycles that provide nutrients to living organisms. it provides a medium for water to move between earth's surface and the air. 4. which of the following is considered a drawback to using wind energy as a source of power? (2 points) wind energy is nonrenewable. wind energy produces large amounts of air pollution. wind turbines can kill birds that fly through the rotors. wind turbines are built too close to major population centers. 5. a meteorologist predicts that the weather in a region will soon change from clear skies to probable thunderstorms. prior to making this prediction, what did the meteorologist most likely observe on a barometer? (2 points) the barometer fell slightly. the barometer fell substantially. the barometer rose slightly. the barometer rose substantially. 6. which of the following do meteorologists not typically use weather balloons to record? (2 points) atmospheric pressure cloud types humidity temperature 7. during which step in the can crush lab did water vapor force air from the can? (2 points) the can was filled nearly to the top with water. the can was placed on the hot stove top burner for several minutes. the can was removed from the hot stove top burner. the can was placed upside-down in the water-filled pan.

Which is a substance that can be separated by physical means and is not the same throughout

Amerry-go-round of radius r, shown in the figure, is rotating at constant angular speed. the friction in its bearings is so small that it can be ignored. a sandbag of mass m is dropped onto the merry-go-round, at a position designated by r. the sandbag does not slip or roll upon contact with the merry-go-round. how would you rank the following different combinations of m and r on the basis of the angular speed of the merry-go-round after the sandbag "sticks" to the merry-go-round from largest to smallest. a) m = 10kg, r = 0.25r b) m = 20kg, r = 0.25r c) m = 10kg, r = 0.50r d) m = 10kg, r = 1.0r e) m = 15kg, r = 0.75r f) m = 40kg, r = 0.25r