subject
Physics, 24.09.2019 01:30 madelyncross24

Afloating object oscillates up and down 2 complete cycles in 1 second as a water wave of wavelength 5 meters passes by. the speed of the wave is

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, markyyy53
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
image
Physics, 22.06.2019 00:30, Hellopeople233
Aball tossed vertically upward from the ground next to a building passes the bottom of a window 1.8 s after being tossed and passes the top of the window 0.20 s later. the window is 2.0 m high from top to bottom. what was the ball's initial velocity? the unit vector j^ is directed upward. how far is the bottom of the window from the launch position? how high does the ball rise above the launch position?
Answers: 1
image
Physics, 22.06.2019 02:30, 22emilyl530
Agas contained within a piston-cylinder assembly undergoes three processes in series: process 12: compression with pv= constant from 1 bar and 1 liter to 4 bar. process 23: constant pressure expansion to 1 liter. process 31: constant volume calculate the pressure and volume at each state, and sketch the processes on a p-vdiagram labeled with pressure and volume values at each numbered stat
Answers: 2
image
Physics, 22.06.2019 14:30, rachel2005smith
Increasing the pressure on one spot of a fluid will increase the pressure everywhere else in the fluid a. pascals principal b. archimedes' principal c. bernoulli's principal
Answers: 1
You know the right answer?
Afloating object oscillates up and down 2 complete cycles in 1 second as a water wave of wavelength...

Questions in other subjects:

Konu
Physics, 17.10.2019 07:50