subject
Physics, 17.10.2019 14:50 pluto82

Amule pulls a cart of milk 10 meters with a force of 50 newton's. calculate the work done by a mule

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 20:40, KekePonds1021
Aloop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. a loop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. moving the loop outside of the magnetic field region. spin the loop such that its axis does not consistently line up with the magnetic field direction. change the magnitude of the magnetic field. change the diameter of the loop
Answers: 1
image
Physics, 22.06.2019 23:00, shelbybibb99
Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.
Answers: 2
image
Physics, 23.06.2019 01:00, dbanks701
Nthe 19th century, women were expected to conform to a certain role that entailed a. gaining domestic skills and establishing a career b. going to college and getting married c. getting married and having children d. graduating from college and being a housewife
Answers: 1
image
Physics, 23.06.2019 07:00, hockejoh000
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
Amule pulls a cart of milk 10 meters with a force of 50 newton's. calculate the work done by a mule...

Questions in other subjects:

Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01
Konu
Mathematics, 14.09.2020 01:01