What feature of a dmm allows you to connect the test probes in the circuit, remove the probes, and then read the measured value on the display? a. diode tester b. minimum/maximum feature c. delta feature d. touch/hold feature which direction do electrons travel? a. they don't move; they simply exchange charge. b. in either direction, depending on the circuit c. from positive to negative d. from negative to positive a circuit contains a 40 ohm resistor and a 60 ohms resistor connected in parallel. if you test this circuit with a dmm, you should read a total resistance value of a. 40 ohms. b. 24 ohms. c. 2400 ohms. d. 2.5 ohms

Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.