subject
Physics, 18.07.2019 20:30 ultimateknight8

Aparticle moves in an elliptical or circular motion. it is most likely a particle in which type of wave? 1.) sound 2.) transverse 3.) longitudinal 4.) surface

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:30, kaylin28
Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33
Answers: 2
image
Physics, 22.06.2019 02:00, llamasking
Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?
Answers: 1
image
Physics, 22.06.2019 08:00, khuak877
Why is it important always to use horizontal bars in unit fractions when performing unit conversions?
Answers: 3
image
Physics, 22.06.2019 12:00, angelamirga332
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
Aparticle moves in an elliptical or circular motion. it is most likely a particle in which type of w...

Questions in other subjects:

Konu
English, 30.10.2020 01:20
Konu
Computers and Technology, 30.10.2020 01:20
Konu
Law, 30.10.2020 01:20
Konu
Mathematics, 30.10.2020 01:20