subject
Mathematics, 15.03.2022 14:00 megnik0714

The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.701 inches in length. At the time when the parts were being manufactured, Engineering had determined that a tolerance of ± 0.037 would be acceptable. i. e. the part would work well if it measured somewhere between 3.664 inches and 3.738 inches. Anything beyond the 3.738 in. would cause "sticking problems". Assuming that each cavity produces the same number of parts, estimate the percent of all the products (parts from all cavities) that could be sticking.


The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.

ansver
Answers: 1

Other questions on the subject: Mathematics

image
Mathematics, 21.06.2019 21:00, kharmaculpepper
Joanie watched 1 out of three of a movie in the morning
Answers: 1
image
Mathematics, 21.06.2019 22:50, kallee10
Type the correct answer in the box. use numerals instead of words. if necessary, use / for the fraction bar.
Answers: 1
image
Mathematics, 21.06.2019 23:50, levigabehart
Apolynomial has two terms. check all of the factoring methods that should be considered. common factor difference of cubes sum of cubes difference of squares perfect-square trinomial factoring by grouping
Answers: 3
image
Mathematics, 22.06.2019 00:30, rayden62
Which image (a’ b’ c’ d’) of abcd cannot he produced using only reflections ?
Answers: 1
You know the right answer?
The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.7...

Questions in other subjects:

Konu
Mathematics, 12.02.2021 01:50