A Type I error is when: the process is in control but the sample size is too small to indicate repeatability the process actually is out of control but your sample suggests that the process is in control the process is not in control but the sample variation is too small the process actually is in control but your sample suggests that the process is not in control

the length of o'p' is .

step-by-step explanation:

it is given that the quadrilateral m'n'o'p' is the image of quadrilateral mnop after dilation.

the center of dilation is origin and the scale factor is 1.5.

in dilation the image and preimge are similar figures. it means the sides of image and preimage are proportional.

the scale factor is defined as

the scale factor is 1.5.

multiply both sides by op.

note: if the value of op is given, then multiply the value of op with 1.5 to get the length of side o'p'.

therefore length of o'p' is .

when rotating a figure 180 degrees, imagine that you are able to take the figure and turn it clockwise or counterclockwise around a center point. to rotate a figure 180 degrees, you will need to apply the rule (x, y) → (-x, -y). start by using a coordinate grid with coordinates for each vertex of the figure. the center point of the coordinate grid is located at (0, 0), which is what you will rotate the figure around. write down the original coordinates of the shape you are going to rotate. then, apply the rule. for example, coordinate (1, 2) becomes (-1, -2). another example would be, coordinate (-4, -2) becoming (4, 2). after you change each original coordinate to the rotated coordinate, you will draw your new figure.

step-by-step explanation:

what