Mathematics, 22.04.2021 16:00 aesthetickait

maria tiene un cubo cristal de 5 cm de lado que quiere atravesar en forma diagonal con un filamento de metal para ver como se refleja la luz cuanto debe medir el filamento para que sobresalga 3cm por cada vertice

Answers: 2

Show answers

Other questions on the subject: Mathematics

Mathematics, 21.06.2019 16:50, abbz13

Factor -8x3-2x2-12x-3 by grouping what is the resulting expression?

Answers: 2

continue

Mathematics, 21.06.2019 19:30, lizzyhearts

Me find the value of x each figure.

Answers: 1

continue

Mathematics, 21.06.2019 21:00, ballbritez

Which line is parallel to the line that passes through the points (2, –5) and (–4, 1) a. y=-x+5 b. y=-2/3x+3 c. y=2/3x-2 d. y=x+5

Answers: 2

continue

Mathematics, 22.06.2019 00:30, oof40

An electrician cuts a 136 foot long piece of cable. one piece is 16 feet less than 3 times the length of the other piece. find the length of each piece

Answers: 1

continue

You know the right answer?

maria tiene un cubo cristal de 5 cm de lado que quiere atravesar en forma diagonal con un filamento...

Questions in other subjects:

Engineering, 13.09.2019 23:20

An orthogonal cutting operation is performed using a rake angle of 15°, to=0.012 in and w=0.100 in. the chip thickness ratio is measured after the cut to be 0.55, material shear st...

Engineering, 13.09.2019 23:20

Write the type of chips generated at each of the following cutting conditions, and explain why. a. low cutting speed: b. large depth of cut: c. very high cutting speed d. low rak...

Engineering, 13.09.2019 23:20

How are the polymeric materials classified? give examples of the plastic materials and elastomers? give the difference between thermoplastics and thermosets what is solution hea...

Engineering, 13.09.2019 23:20

What is components? what is phases? what is tie line?...

Engineering, 13.09.2019 23:20

Avariable speed reciprocating compressor of mass 400 kg has a natural frequency of 16.2 hz. (a) design an optimum auxiliary mass damper, so that the maximum dynamic magnification f...

Engineering, 13.09.2019 23:20

Specific cutting energy increases with increasing the cutting speed. a) true b) false...

Engineering, 13.09.2019 23:20

Two standard spur gears have a diametrical pitch of 10, a center distance 3.5 inches and a velocity ratio of 2.5. how many teeth are on each gear?...

Engineering, 13.09.2019 23:20

Consider a wind turbine subjected to 30 km/hr steady winds. if the turbine produces 480 kw of power and the velocity downstream of the wind turbine is 25 km/hr, determine the turbi...

Engineering, 13.09.2019 23:20

You are traveling in an airplane. the engineer who designed it is, casually, on your side. he tells you that the wings were designed using the von mises criterion. would you feel s...

Engineering, 13.09.2019 23:20

Cost of machining operations is primarily affected by tool life, power consumed and workpiece material. a) true b) false...

More questions: Mathematics Another questions