Which function is positive for the entire interval [–3, –2]? On a coordinate plane, a curved line with a minimum value of (0, negative 3) crosses the x-axis at (negative 3, 0) and (3, 0), and crosses the y-axis at (0, negative 3).

On a coordinate plane, a curved line with a minimum value of (2, negative 3) crosses the x-axis at (negative 1, 0) and (5, 0), and crosses the y-axis at (0, negative 1.5).

On a coordinate plane, a curved line with a minimum value of (2, 4) and a maximum value of (0.5, 6), crosses the x-axis at (negative 1.5, 0) and crosses the y-axis at (0, 5).

On a coordinate plane, a curved line with a minimum value of (negative 1.75, negative 3.9) and a maximum value of (0, 2), crosses the x-axis at (negative 2.2, 0), (negative 0.75, 0), and (0.75, 0), and crosses the y-axis at (0, 2).

Find the rate of change for the situation. you run 7 miles in one hour and 21 miles in three hours.

Henry's butcher shop uses an electronic scale that measures to 1/100 of a pound. which is the most accurate measurement based on the limitations of the scale that might be found on a package of meat sold by henry?

When constructing a perpendicular line through a point off a line, how can you verify that the lines constructed are perpendicular? check the angles used in the construction with a straightedge to ensure consistency. check the distance along the lines at several places with a compass to ensure they are the same length. check the intersecting lines with the corner of a piece of paper to ensure the lines create 90° angles. check the distance between the lines at several places with a compass to ensure they are equidistant. question 2(multiple choice worth 1 points) (01.03 lc) which of the following steps is included in the construction of a perpendicular line through a point on a line? connect arcs that are above and below the given line with a straightedge. connect arcs that are above the original line with a straightedge. create arcs on either side of a point that is off the given line. create a copied angle by using the first two lines as the original angle.