HURRY THIS IS MY LAST THING FOR THIS ASSIGNMENT. Maria is using a coordinate plane with the axes labeled only with integers. She says that the point (−0.5, 2) cannot be plotted because halves are not numbered on the x-axis. Write a note to Maria about her misunderstanding and explain how to plot the point.

You can have halves of points, Just because I have 0 units and 1 units doesn't mean that I can't put a point in the middle of the two. You could put a point in the middle of a unit for 0 - 1 it would be 0.5. You would place it in the middle of the unit

Step-by-step explanation:

You can plot points that contain decimal numbers on a coordinate plane even if only integers are labeled on the axes. To plot (−0.5, 2), start at the origin and move left 0.5 units. This will be halfway between −1 and 0. Then move up 2 units and plot a point.

Step-by-step explanation:

its the sample response, so word it differently <3

d. millimeters per hour.

step-by-step explanation:

we are given that,

carlo used a rain gauge to measure the amount of water his lawn is receiving from the sprinklers.

since, according to the options, we see that,

water cannot be measured by 'miles per hour', 'meters per second' and 'grams per seconds'.

we get that, the water can be measured by 'millimeters per hour'.

hence, the appropriate rate for describing the amount of water is 'millimeters per hour'.

see attached

step-by-step explanation:

given the function as;

write the equation replacing f(x) with y

form   and fill a table containing values of y with corresponding values of x

you can take a range for   values of x as -3≤x≤3

solving for x=-3

for x=-2

repeat the same procedure to get the values of y for the remaining ,x=-1 to x=3

plot the values of y against values   of x and obtain the following graph