A set of plans shows that an opening in a bulkhead is needed for a section of pipe to pass through. The plans show metric values, but the only tape measure available is marked in inches. The pipe is shown as a size DN80 (a European pipe-sizing standard), and a chart indicates the outside diameter of DN80 pipe is 88 millimeters (mm). According to the plans, all openings must be 40 mm larger than the pipe. You know that 25.4 mm is equal to one inch. What is the diameter of the needed opening in inches? Round your answer to the nearest whole inch.

bdhfnfhjffjkfjfjfjjf

c

step-by-step explanation:

statement #3: proof- ang is congruent to ang ecd : angles are congruent.  

step-by-step explanation:

1: the missing angles in statement #3  

a.) acb  

reason- the reason why the answer is acb is because angle ecd and angle acb are both the same size *that's what the word congruent means this is really simple.  

2: the missing word in reason #3  

c.) vertical  

reason- the reason why the answer is vertical is because the angles in that diagram on figure 2 is slanted, which is vertical, and the e and a both lay on vertical lines. along with the other's, but e and a are the 2 main points you want to focus on. and c is kind of like your starting point, because c is for both angles, not just one.  

i hope that was and understanding.

when the daily mileage is greater than 40 miles, unlimited mileage plan will save you money. 40 miles is the break-even point.

step-by-step explanation: