Mathematics, 25.10.2019 01:43 ktprada

Arouter is used to cut locating notches on a printed circuit board. the vibration level at the surface of the board as it is cut is considered to be a major source of dimensional variation in the notches. two factors are thought to influence vibration: bit size (a) and cutting speed (b) are thought to influence the vibration level. two bit sizes (1/16 and 1/8 inch) and three speeds (40, 60, and 90 rpm) are selected, and four boards are cut at each set of conditions. the vibration level is measured on each board cut.

(a) what is the response variable?

(b) what is (are) the factor(s)

(c) what are the levels of each factor?

(d) how many replicates are there?

Answers: 3

Show answers

Other questions on the subject: Mathematics

Mathematics, 21.06.2019 15:30, DJEMPGYT

Will give are given that xy is parallel to zw. if xz is a transversal that intercepts xy and zw, angle angle alternate interior angles. since xy is parallel to zw, we know that these angles are we also know that angle xvy and angle zvw are , and thus congruent. we can conclude that △xyv ~ △zwv using the similarity theorem.

Answers: 2

continue

Mathematics, 21.06.2019 21:20, DisneyGirl11

The edge of a cube was found to be 30 cm with a possible error in measurement of 0.4 cm. use differentials to estimate the maximum possible error, relative error, and percentage error in computing the volume of the cube and the surface area of the cube. (round your answers to four decimal places.) (a) the volume of the cube maximum possible error cm3 relative error percentage error % (b) the surface area of the cube maximum possible error cm2 relative error percentage error %

Answers: 3

continue

Mathematics, 21.06.2019 21:30, kingdrew27

Due to a packaging error, 4 cans labeled diet soda were accidentally filled with regular soda and placed in a 12 pack carton of diet soda. two cans were randomly selected from this 12 pack. what is the probability that both cans were regular soda?

Answers: 2

continue

Mathematics, 22.06.2019 01:00, mandy9386

Def rotates 90 clockwise about point a to create d’ e’ f’. therefore, which equation must be true ?

Answers: 2

continue

You know the right answer?

Arouter is used to cut locating notches on a printed circuit board. the vibration level at the surfa...