subject

Mathematics, 27.09.2019 08:30 CDMJ8320

5. two more than one-fourth of a number is six, what is the number.

ansver

Answers: 2

Show answers

Other questions on the subject: Mathematics

Mathematics, 21.06.2019 16:00, soso585oo

The graph shows the function f(x) = (2.5)x was horizontally translated left by a value of h to get the function g(x) = (2.5)x–h.

Answers: 1

Mathematics, 21.06.2019 20:00, beverlyamya

Three baby penguins and their father were sitting on an iceberg 0.50.50, point, 5 meters above the surface of the water. the father dove down 4.74.74, point, 7 meters from the iceberg into the water to catch dinner for his kids. what is the father penguin's position relative to the surface of the water?

Answers: 2

Mathematics, 21.06.2019 21:00, latinotimo7643

With both problems. a. s.a. p directions on photo ^

Answers: 1

Mathematics, 22.06.2019 02:20, chaparro0512

Factor this polynomial completely. x^2-8x+12

Answers: 2

You know the right answer?

5. two more than one-fourth of a number is six, what is the number....

Questions in other subjects:

Konu

Engineering, 26.07.2019 17:20

Arigid tank contains water vapor at 300° c and an unknown pressure. the vapor starts condensing. the cooling continues until all vapors have path and indicate the initial and final...

Konu

Engineering, 26.07.2019 17:20

Which of the following characterizes a un-cold-worked steel in comparison with a cold-worked steel? i. higher yield strength ii. better surface smoothness iii. greater hardness iv...

Konu

Engineering, 26.07.2019 17:20

If the turbulent velocity profile in a pipe 0.6 m in diameter may be approximated by -3.56y1/7 where v is in m/s and y is in m, and the shearing stress in the fluid 0.15 m from the...

Konu

Engineering, 26.07.2019 17:20

Afixture will be designed to hold a part in a vise that will be produced in mass quantities. the rner closest to the mill oper a suitable fixture. the sketch should depict an appro...

Konu

Engineering, 26.07.2019 17:20

The principle for strengthening metals/alloys is creating barriers to dislocation motion in their microstructures. then, what are the barriers to dislocation motion in each of the...

Konu

Engineering, 26.07.2019 17:20

What does the charpy test determine? (a) yield strength (b) fracture strength (c) young's modulus toughness e) ductility...

Konu

Engineering, 26.07.2019 17:20

Which of the following is the primary factor in determining if a sheet metal can be bent and formed into another shape without experiencing fracture and other undesirable defects (...

Konu

Engineering, 26.07.2019 17:20

Steam expands in a turbine from 6 mpa, 500°c and 80 m/s to 0.2 mpa, 150°c and 140 m/s at a rate of 1.2 kg/s. heat is lost from the turbine at a rate of 34 kj/s during the process....

Konu

Engineering, 26.07.2019 17:20

What are the four types of defects in crystalline metal materials?...

Konu

Engineering, 26.07.2019 17:20

Find the contact ratio for a pair of spur gears with a center distance of 4.125 in. if the gears have 19 and 80 teeth respectively and a normal pressure angle of 20 degrees....

More questions: Mathematics Another questions