subject
Engineering, 22.01.2022 02:40 jimmyjimjim

For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED is 2.0V and LED is 1.4V. Calculate current I, that flows through Resistor Rz
i
If the switch S1 is closed and S2 is open
i. If the switch S2 is closed and S1 is open
in. If both the switches are closed


For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED is 2.0V

and LED is 1.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 19:20, amandaaarmentaa
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
image
Engineering, 06.07.2019 02:30, piperk19
Define thermoplastic polymers and thermosetting polymers in terms of their structures, and (ii) describe briefly a process suitable for the production of products from each type of polymer.
Answers: 3
You know the right answer?
For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED is 2.0V and LED is 1.4...

Questions in other subjects:

Konu
Medicine, 18.11.2020 01:00