Engineering, 12.01.2022 14:00 spalmer8

In what type of defrost system is air from the conditioned space circulated over the evaporator when the compressor is not running

Answers: 2

Show answers

Answers

An off cycle defrost is just as it sounds; defrosting is accomplished by simply shutting off the refrigeration cycle, preventing refrigerant from entering the evaporator. Even though the evaporator might be operating below 32F, the air temperature in the refrigerated space is above 32F.

On low temperature applications, off cycle defrost is not practical given that the air in the refrigerated space is below 32F. Therefore, in addition to shutting off the refrigeration cycle, an external source of heat is required to raise the evaporator temperature.

Answer from: Quest

answer:

i lost in getting someone back.

i learned that people are really two-faced and no matter how angelic someone appears they always have a devil side and that you cant trust anyone anymore no matter how dear they are to you.

if your wondering who it waz it waz mah still miss her tho

~batmans wife dun dun

Answer from: Quest

Answer: yesexplanation:

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 19:10, pedropaulofpedrosapp

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 3

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

Engineering, 06.07.2019 04:20, Okeh4001

An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced

Answers: 1

continue

You know the right answer?

In what type of defrost system is air from the conditioned space circulated over the evaporator when...