subject
Engineering, 03.01.2022 17:40 caroline5993

Two technicians are discussing engine coolant temperature (ECT) sensor diagnosis. Technician A says that the correct function of an ECT sensor depends on having a properly filled cooling system. Technician B says that the voltage measured on the ECT signal wire should be low when the engine is cold and high when the engine is hot. Who is correct

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, aaliyah80
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
Two technicians are discussing engine coolant temperature (ECT) sensor diagnosis. Technician A says...

Questions in other subjects:

Konu
Mathematics, 02.03.2020 18:00