Engineering, 21.12.2021 14:40 smortandsons

A cantilever beam AB, loaded by a uniform load and a concentrated load (see gure), is constructed of a channel section. (a) Find the maximum tensile stress st and maximum compressive stress s c if the cross section has the dimensions indicated and the moment of inertia about the z axis (the neutral axis) is 3.36 in4 I 5 . Note: The uniform load represents the weight of the beam. (b) Find the maximum value of the concentrated load if the maximum tensile stress cannot exceed 4 ksi and the maximum compressive stress is limited to 14.5 ksi. (c) How far from A can load P 5 250 lb be positioned if the maximum tensile stress cannot exceed 4 ksi and the maximum compressive stress is limited to 14.5 ksi

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 19:20, lovenahofer

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

continue

Engineering, 06.07.2019 03:30, Scotdouglas346

Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)

Answers: 1

continue

You know the right answer?

A cantilever beam AB, loaded by a uniform load and a concentrated load (see gure), is constructed of...