Engineering, 14.12.2021 01:20 babyduck0664

1. Flexural Strenght Determination : Test prism No. 1: Length 159.4 mm Width: 40.0 mm Height: 40.0mm

Mass : 582 g Maximum Load: 3.6 KN

Test Prism No. 2: Length : 159.4 mm Width: 40.0 mm Height: 40.0mm

Mass: 575 g Maximum Load: 3.6 KN

Test Prism No. 3: Length : 159.6 mm Width: 40.0 mm Height: 39.9 mm

Mass: 586 g Maximum Load: 3.6 KN

2. Compressive Strength Determination :

Maximum Load (prism halves) (kN) : 82.0 84.3 75.7 80.4 71.8 74.2

Decide, if the test is valid according EN 197-1!

Decide, if the cement complies with the requirements of EN 197-1

1. Flexural Strenght Determination :

Test prism No. 1: Length 159.4 mm Width: 40.0 mm Height: 40.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

You know the right answer?

1. Flexural Strenght Determination : Test prism No. 1: Length 159.4 mm Width: 40.0 mm Height: 40.0...