A workpiece 2-in in diameter is to be machined on a lathe to 1.5-in in diameter. The total length of the workpiece is 3-in. It is recommended from handbook that a feed of 0.06 ipr, a cutting speed of 208 fpm, and a maximum depth of cut of 0.1-in be used. A 0.25-in overtravel should be used for cutter clearance. How long will it take to finish the part in minutes

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.