Engineering, 02.12.2021 18:20 sarah5557

A 7 cm diameter bed on a 25 cm long bed, as shown in the figure below. The shaft rotates at 3200 revolutions per minute with uniform intervals of 0.2 mm. Continuous operation
The temperatures of the shaft and bearing adjacent to the oil gap are 55 0C. your oil
viscosity 0.05 N. s/m2

and its thermal conductivity is 0.17 W/m. K. Continuity, momentum and

by simplifying the energy equations and solving for each separately,

a) The maximum temperature of the oil,
b) Calculate the heat transfer rates to the bearing and shaft.

A 7 cm diameter bed on a 25 cm long bed, as shown in the figure below.

The shaft rotates at 3200

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

You know the right answer?

A 7 cm diameter bed on a 25 cm long bed, as shown in the figure below. The shaft rotates at 3200 r...