Engineering, 02.12.2021 17:00 tyrique86

Figure 3 illustrates the stress-strain diagram for tensile test of four (4) different materials and labelled as A, B, C and D. Each tested sample is 10 mm in diameter with a gauge
length of 50 mm. From the diagram,
i)
) Identify the material with the largest modulus of elasticity and state its value.
[2 Marks]
ii) Identify the material with the maximum ultimate tensile strength and state its value.
[2 Marks]
iii) Identify the material with the highest failure strength and state its value.
[2 Marks)
iv) Identify the material with the lowest yield strength and state its value.
[2 Marks]
v) Predict the suitable material among A, B, C and D for the used in construction.
Give TWO (2) reasons.
[2 Marks)

Figure 3 illustrates the stress-strain diagram for tensile test of four (4) different materials

a

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

You know the right answer?

Figure 3 illustrates the stress-strain diagram for tensile test of four (4) different materials an...