subject
Engineering, 25.11.2021 14:00 whitethunder05

A refrigeration cycle driven by an electric motor must maintain a computer laboratory at 188C when the outside temperature is 308C The thermal load consists of heat transfers entering through the walls and roof of the laboratory at a rate of 75,000 kJ/h and from the computers, lighting, and occupants at a rate of 15,000 kJ/h. Required:
a. Determine the minimum theoretical power required by the electric motor, in kW, and the corresponding coefficient of performance.
b. If the actual power required by the motor for this duty is 8.3 kW, determine the coefficient of performance.
c. If the given temperature and thermal load data are observed for a total of 100 hours and electricity costs 13 cents per kWh, determine the cost, in $, over that period for each of cases (a) and (b).

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
image
Engineering, 06.07.2019 02:30, chickennbutt0730
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
You know the right answer?
A refrigeration cycle driven by an electric motor must maintain a computer laboratory at 188C when t...

Questions in other subjects:

Konu
Social Studies, 28.01.2020 20:55