Engineering, 25.10.2021 07:30 savannahvargas512

Q9 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 16 3 0
P2 3 1 5
P3 5 5 8
P4 6 4 4
P5 11 2 6
For the set of processes directly above, draw a Gantt chart for the Round Robin
Scheduling Algorithm using. CS=0
a) For the set of processes directly above, draw a Gantt chart for the the Round
Robin Algorithm for a time quantum of q= 5 ms.
b) For the set of processes directly above, calculate the throughput for the
Round Robin Algorithm for a time quantum of 5 ms.
c) For the set of processes directly above, calculate the turnaround time for the
Round Robin Algorithm for a time quantum of 5 ms.
d) For the set of processes directly above, calculate the average turnaround
time for the Round Robin Algorithm for a time quantum of 5 ms.
e) For the set of processes directly above, calculate the waiting time for the
Round Robin Algorithm for a time quantum of 5 ms.
f) For the set of processes directly above, calculate the average waiting
time for the Round Robin Algorithm for a time quantum of 5 ms.
g) What will happen if the time quantum for the Round Robin Algorithm is too
small?
h) What will happen if the time quantum for the Round Robin Algorithm is too
large?
i) What is the CPU Utilization for the system?
Q 10: Repeat Q9 with CS=1

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

You know the right answer?

Q9 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 16 3 0
...