Engineering, 25.10.2021 07:20 JvGaming2001

Q 1: Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
P2 3 1 0
P3 5 5 0
P4 4 4 0
P5 10 2 33
For the set of processes directly above, draw a Gantt chart for the FCFS
Scheduling Algorithm. For context switch (CS =0)
a) For the set of processes directly above, calculate the throughput for the
FCFS (First Come First Serve) Scheduling Algorithm.
b) For the set of processes directly above, calculate the turnaround time for
the FCFS (First Come First Serve) Scheduling Algorithm.
c) For the set of processes directly above, calculate the average turnaround
time for the FCFS (First Come First Serve) Scheduling Algorithm.
d) For the set of processes directly above, calculate the waiting time for the
FCFS (First Come First Serve) Scheduling Algorithm.
e) For the set of processes directly above, calculate the average waiting
time for the FCFS (First Come First Serve) Scheduling Algorithm.
f) What is the SJF (Shortest Job First) Scheduling Algorithm?
g) What is the CPU Utilization for the system?
Q2 : Repeat Q1 with CS=1

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 19:10, babas97

What is a monomer? how do they form a ploymer from the view point of chemical bonding?

Answers: 1

continue

You know the right answer?

Q 1: Assume the Following Process. Process Burst Time Priority Arrival Time
P1 18 3 0
...