Engineering, 23.10.2021 14:00 donnafranks2003

A temperature control system is designed to maintain the temperature at a constant value of 500 C inside an induction furnace.
126 Chapter 4
(a) The following test set of initial temperature measurements (once the furnace
temperature has reached steady state) is obtained: 507 502 520 500 492 485 499
495 497 500 516 501 489 503 490 481 504 511 499 512
Show that this is free of rogue data points and can therefore be used as a reference set against which to test future temperature measurements.
(b) The temperature is then measured at 10 min intervals and the following 20 measurements are obtained:
481 505 495 519 498 1015 508 477 500 526 501 488 502 492 464 503 499 510
515 497
Test whether there are any rogue measurements in this data set.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

You know the right answer?

A temperature control system is designed to maintain the temperature at a constant value of 500 C...