3. Which of the following is a critical step in using a circular saw safely?
A. Make the cut along a straight line.
B. Use only thick kerf blades on
dimension lumber.
C. Keep the cord where you can see it to
prevent damage.
O D. Reverse the blade on softer woods and
plastics

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

A200-mm wide strip 25 mm thick is fed through a rolling mill w/two powered rolls each of radius = 250 mm. the work thickness is to be reduced to 22 mm in one pass at a roll speed of 60 rev/min. the average flow stress of the work material, as it passes through the rolls is 175 mpa. the friction coefficient between rolls and work material is 0.20. 1, determine a)-if friction is sufficient for rolling. b)- if friction is sufficient: c)- calculate roll force i calculate roll torque. d)- calculate roll power.