Engineering, 26.09.2021 14:30 tsvijay121

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is to be waterjet cut from Aluminum (Al-6061-T6, density= 2.7 g/cm3) 0.063" thick plate stock costing
$12/pound. Water jet machine runs at a constant cutting speed of 200 mm/min, at an operating cost
of S20/hr.
1) Find the coordinate point of vertexes A to T to be used for CNC waterjet cutting machine.
2) Estimate the material cost per part.
3) Estimate the machining cost per part.
Drawing: All dimensions in inch. CNC starting point is at A= (2,2). Vertical dash line indicates line
of mirror symmetry

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Talos02

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

You know the right answer?

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is t...