subject
Engineering, 07.09.2021 19:40 christhegreat1

problem 2 (25 pts) design a low pass butterworth filter to remove high frequency noise from a signal with a nyquist frequency of 1000 hz meeting the following design requirements: 1. the dynamic error to be less than 0.01 at 500 hz or lower frequencies and 2. the attenuation at 4.5 khz or higher frequencies to be at least 25 db the filter cutolt frequency is to be 1500 hz. take the source and load impedances as 50 n. part a) 10 pts find the order of the butterworth filter required lo mcet the above design criteria. part b) 10 pts find the values of the capacitors and inductors required to construct the filter and draw a circuit dingram of the filter. part c) 5 pts at what lowest frequency this signal must be sampled so that signal aliasing is avoided

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, alexis9263
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
image
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
image
Engineering, 06.07.2019 03:30, carolina1636
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.
Answers: 2
image
Engineering, 06.07.2019 04:10, johnbobjones
Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump
Answers: 1
You know the right answer?
problem 2 (25 pts) design a low pass butterworth filter to remove high frequency noise from a signal...

Questions in other subjects:

Konu
English, 12.02.2021 21:10
Konu
Mathematics, 12.02.2021 21:10