Engineering, 26.08.2021 05:10 lb31224

Before using a chisel or punch check to see that the head is: not mushroomed
o not rusty
polished
oil soaked
Welding question

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 19:10, Destinationz

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Engineering, 06.07.2019 05:20, BluHope19

Adrawing operation is to be performed on a perfectly plastic material with strength coefficient- 100 mpa and strain hardening exponent-0. neglect redundant strain. die/work material friction coefficient=0 a)-what is the drawing stress? if this stress is a function of the area reduction, state so. b)-what is the strength of the material after drawing? if this strength is a function of the area 4. reduction, state so. c)-what is the maximum area reduction possible?

Answers: 3

continue

You know the right answer?

Before using a chisel or punch check to see that the head is: not mushroomed
o not rusty