Engineering, 18.08.2021 14:00 culturedxnat

The figure is like aschematic drawing of asolid counter shaft that supports two that belt Pullers each having ason weight. For each pulley, the belt gensions are parallel and the coefficient is friction between the belt and Pelley Ais dits. If a cold-drawn uns Glo 180 steel shast a vitorm diameter in material properties of allowable strength in shea, and in benders may be taken as 220 MPa and 440 MPa respectively. Determine the minimum Preferred size diameter in accordance to the ASME code usino km= 15 and Ke=10. Neglect the effect a mass and thickness of belts and mass of the shaft

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, brid7931

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

continue

You know the right answer?

The figure is like aschematic drawing of asolid counter shaft that supports two that belt Pullers ea...