Engineering, 13.08.2021 02:10 dozsyerra

For a compression spring with 1 inch OD was made by 0.1inch diameter hard-drawn wire. The spring with 6inch free length has squared end and is peened. The spring was compressed to 5 inch (a kind of pre-load condition) (hint: Fmin is not zero) during machine installation. Then, the spring is used in a machine by compressing it from 5inch (pre-compressed) into a solid length of 4 inch. Determine:
a. Spring rate
b. the fatigue factor of safety when repeatedly cycled from 5-inch length (pre-load condition) to solid length.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

You know the right answer?

For a compression spring with 1 inch OD was made by 0.1inch diameter hard-drawn wire. The spring wit...