Engineering, 05.08.2021 14:00 dmgcity

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one second theodolite, are: Angle ABC BCD CDE DEF EFA FAB Mean observed Value 272 03' 10" 272°05' 51" 104° 50' 31" 261° 11'06" 266° 10' 15" 263° 38' 25" (a) Determine the sum of the measured angles. (5 marks) (b)Determine the angular error of the traverse. (5 marks) (c) Adjust the angles of the traverse to eliminate the error. (5 marks) (d) Given that the whole circle bearing of line AB is 43°40'45", calculate the bearings of all other lines of the traverse. (20 marks) The sum of exterior angles = 62n+4) * 90

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one sec

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

You know the right answer?

Question 1 m(35 marks) The values of the exterior angles in the figure shown, measured by a one seco...