Engineering, 22.07.2021 02:00 gonzo8953

2. The condenser and evaporator of a refrigerator with refrigerant-134a as the working fluid work at the constant pressures of 200 psia and 25 psia respectively. The mass flow rate of the refrigerant in the cycle
is 5 lbm/min. The condenser rejects heat to cooling water that enters the condenser at 40°F at a rate of 25.297
lbm/min and leaves at 55°F. The exit of the evaporator (state 1) is saturated vaper but the exit of the condenser
(state 3) is not saturated liquid. The work consumed by the compressor is 23.48 Btu/lbm and the estimated
heat gain of the compressor from the surroundings is 0.81 Btu/lbm. Determine
(a) the enthalpy and temperature at the condenser inlet (h2 and T2)
(b) the enthalpy and temperature at the condenser outlet (h3 and T3)
(c) the refrigeration load in Btu/min
(d) the COP of the refrigerator.
Water
Water
55°F
40°F
Он
Condenser
P= 200 psia
3
2
Qin
Expansion
valve
Win
Compressor
4
Evaporator
P= 25 psia
1
QL

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

You know the right answer?

2. The condenser and evaporator of a refrigerator with refrigerant-134a as the working fluid work at...