Engineering, 15.07.2021 20:40 dhernandez081

In a chemical plant 240kmol combustible gas mixture with 20% excess air is fed into a burner unit. The gas product from the burner is cooled to remove all the water to yield a dry gas. The Orsat analysis of this flue gas shows that for every 2kmol CO2 produced; 3kmol CO is produced. (Ratio of CO2 /CO produced is 2/3) Analysis of the combustible gas mixture fed into the burner: 60% CH4, 20% C2H4, 10% CO, 5% O2 , 5%N2 2.1 Calculate the amount of water removed from the system (kmol) 2.2 Calculate the amount of air fed into the system (kmol)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

You know the right answer?

In a chemical plant 240kmol combustible gas mixture with 20% excess air is fed into a burner unit. T...