Engineering, 12.07.2021 16:00 smileymanielle1

A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickness onto another tube of 250 mm external diameter and 25 mm wall thickness, both tubes being made of the same material. The stress set up at the junction owing to shrinkage is 10 MN/m2. The compound tube is then subjected to an internal pressure of 80 MN/m2. Find the shrinking allowance.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

You know the right answer?

A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickne...