Engineering, 11.07.2021 23:50 darkghostmist
) A hydraulically operated multidisk plate clutch has an effective disk outer diameter of 160 mm and an inner diameter of d mm. There are six sliding planes. The coefficient of friction (f) is 0.20 and the maximum pressure (Pa) is 900 kPa.
(a) Using the uniform wear model, estimate the axial force.
(b) Calculate the inner diameter of the plates for maximum torque and determine the maximum Torque
(hint: differentiate torque T with respect to inner diameter of d).
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 19:10, pjgolden04
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
Engineering, 04.07.2019 19:10, Mimidj9279
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
You know the right answer?
) A hydraulically operated multidisk plate clutch has an effective disk outer diameter of 160 mm and...
Questions in other subjects:
