Engineering, 01.07.2021 01:00 toribrown3773

) Determine the rate of heat exchange between the two liquids. (worth 6/45pt) b) Determine the heat capacity rate of the 'cold' fluid (worth 6/45pt) c) Determine the heat capacity rate of the 'hot' fluid (worth 6/45pt) d) Determine the effectiveness of the heat exchanger (worth 9/45pt) e) Determine the number of transfer units (NTU) (worth 12/45pt) f) Determine the overall heat transfer coefficient. (worth 6/45pt)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, mamasbug4285

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

continue

You know the right answer?

) Determine the rate of heat exchange between the two liquids. (worth 6/45pt) b) Determine the heat...