Engineering, 27.06.2021 14:00 asianraisins66

Check the adequacy of a cantilovor beam if tho section is a UB 356x1Zx51 of stool grade S355 (= 355 MPa = 470 MPa). as shown below. Thore is no latoral support other than at the fixed ond Use an unbracod length oqual to tho span longth Tho beam supports a permanent aation of 12cm concrete slab with a strip width of 4 m (normal-woight concrete=25 KN/m) and the imposed action is 3 kN/m?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

Engineering, 04.07.2019 19:10, rayne40

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

continue

You know the right answer?

Check the adequacy of a cantilovor beam if tho section is a UB 356x1Zx51 of stool grade S355 (= 355...