subject
Engineering, 24.06.2021 02:40 alexandradumit3086

A horizontal piston/cylinder arrangement is placed in a constant-temperature bath. The piston sides in the cylinder with negligible friction and an external force holds it in place against an initial gas pressure of 14 bar. The initial gas volume is 0.03 m3. The external fore on the piston is reduced gradually and the gas expands isothermally as its volume triples. If the volume of the gas is related to its pressure so that the product PV is constant. (a) What is the work by the gas in moving the external force?
(b) How much work would be done if the external force were suddenly reduced to half its initial value instead of being gradually
reduced?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:20, Doogsterr
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
You know the right answer?
A horizontal piston/cylinder arrangement is placed in a constant-temperature bath. The piston sides...

Questions in other subjects:

Konu
Mathematics, 28.10.2020 06:00