![subject](/tpl/images/cats/User.png)
Engineering, 21.06.2021 16:20 sheila54
Determine the motor size required to pump 1000 cfs through a 10,000 ft long 12.0 ft diameter pipeline to an upper reservoir 2000 ft above the reservoir. Use a friction factor of 0.02 and pump efficiency of 80 percent. Compute the energy input to the motor, if the motor efficiency is 90%.
![ansver](/tpl/images/cats/User.png)
Answers: 1
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, oshawn108
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
Determine the motor size required to pump 1000 cfs through a 10,000 ft long 12.0 ft diameter pipelin...
Questions in other subjects:
![Konu](/tpl/images/cats/ekonomika.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/obshestvoznanie.png)
![Konu](/tpl/images/cats/ekonomika.png)
![Konu](/tpl/images/cats/ekonomika.png)
![Konu](/tpl/images/cats/ekonomika.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/himiya.png)
![Konu](/tpl/images/cats/mat.png)