Engineering, 11.06.2021 14:40 bks53

Two technicians are discussing oil and filter changes. Technician A says that there should be a gasket in place on a spin-on oil filter when removed, and if not, that you should make sure the gasket isn’t stuck to the engine mount. Technician B says that you loosen the oil-drain plug slowly using a screwdriver. Which technician is correct?
A. Technician A only
B. Both Technicians A and B
C. Neither Technician A nor B
D. Technician B only

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

You know the right answer?

Two technicians are discussing oil and filter changes. Technician A says that there should be a gask...