Engineering, 10.06.2021 08:50 barnhill4755

Cantilever beam in the figure is loaded with force F. After that with help of strain gauges 1 and 2, unit elongations were measured (gauge 1 is at the top of the beam with 45 degree to the beam axis and gauge 2 is located at left side at z=0, see top view to ensure. ) Calculate the force F and length with given material properties and gauge lengths. Note that length of the beam is not important to solve this question GİVEN: E=2.10^7 N/cm^2,d=10cm, G=8.10^6 N/cm^2,a=45 cm,ε1=385.15x10^-6,ε2=240.10x10^-6

Cantilever beam in the figure is loaded with force F. After that with help of strain gauges 1 and 2

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, nandalabella06

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

You know the right answer?

Cantilever beam in the figure is loaded with force F. After that with help of strain gauges 1 and 2,...