Engineering, 08.06.2021 14:00 live4dramaoy0yf9

) The slab shown below is loaded with D = 8 kN/m2 and L= 4 kN/m2
. All beams are 300
mm in width and 600 mm in depth and all columns are square with side length of 300
mm. If the slab is 200 mm thick and is reinforced with 10 mm diameter bars in both
directions, then:
(a)Calculate the design moment of the slab at A.
(b)Calculate the uniformly distributed load on beam B1.

) The slab shown below is loaded with D = 8 kN/m2

and L= 4 kN/m2. All beams are 300 mm in width a

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

You know the right answer?

) The slab shown below is loaded with D = 8 kN/m2 and L= 4 kN/m2
. All beams are 300
mm...