Engineering, 27.05.2021 07:40 alondrasanchezvillan
Hey answr this sajida Yusof
Answers: 2
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Engineering, 04.07.2019 19:20, natalie2sheffield
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
Engineering, 06.07.2019 04:10, monstergirl25
Steam enters a converging nozzle at 3.0 mpa and 500°c with a negligible velocity, and it exits at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: is isentropic (a) (b) has an efficiency of 94 percent
Answers: 1
Hey answr this sajida Yusof...
Mathematics, 28.08.2019 21:00
Mathematics, 28.08.2019 21:00
Physics, 28.08.2019 21:00
Geography, 28.08.2019 21:00
History, 28.08.2019 21:00