subject
Engineering, 19.05.2021 18:50 tammydbrooks43

A new development is being proposed over a 10 acres site. The developer wants to divide the site into 40 lots and have a single-family home at each lot. Each home will take about 40 percent of the lot size. 30% of the lot will be landscaped with shrubs, the rest of the lot will be lawns and sidewalks. After finishing developing the site, the first rainfall of the season hits the development. The rainfall lasted for 3 hours with an average of 0.51 in/hr. Geotechnical report prepared as part of the city permit requirement showed that the initial infiltration was 0.32 in/hr, the final was 0.15in/hr, and decay constant was 0.1 Shr-1. Some residents complained that there was water accumulated at their properties cause some damages. Residents threatened to take legal action against the developer. The developer hired your company to investigate what had happen. You are assigned to the project and been asked by your supervisor to perform the following calculations: 1. What is the interception?
2. What is the infiltration?
3. In your opinion and based on your analysis do you believe that the residents allegations are founded?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, 19deleonl
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:20, luisgonz5050
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
You know the right answer?
A new development is being proposed over a 10 acres site. The developer wants to divide the site int...

Questions in other subjects:

Konu
Social Studies, 27.08.2019 20:30
Konu
Mathematics, 27.08.2019 20:30