subject
Engineering, 14.05.2021 18:20 poppy4195

3. An 8 foot long joist has an actual cross section of 1.5" x 11.5". A load of 2,500 pounds will be applied as shown in the diagram.
a. Calculate the area moment of inertia for the joist.
in"
(report to x. x decimal places)
Load
1
11.5 in.
1.50 in.
b. Given the modulus of elasticity of the beam is 29,000,000 psi, what will the
deflection be? inches. (report to x. xxx decimal places)


3. An 8 foot long joist has an actual cross section of 1.5 x 11.5. A load of 2,500

pounds will

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
3. An 8 foot long joist has an actual cross section of 1.5" x 11.5". A load of 2,500 pounds will be...

Questions in other subjects: