Engineering, 12.05.2021 04:00 iisofieii1978

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet engine turbine blades? The yttria content of the top coat layer (columnar grains) should be maximized and should exceed at least 15 wt% in the ceramic.
The yttria content of the bonding layer should be maximized and should exceed at least x = 1.0 within a bonding layer of Ni-16-Cr-5Al-xY.
The coefficients of thermal expansion for the TBC sublayers should be matched as close as possible to prevent thermal stresses that could promote cracking and spalling of the TBC. [Select] The thermal conductivities of the TBC sublayers should be matched as close as possible to the underlying base metal (usually a Ni-based superalloy).
Air gaps between grains of top coat 7TZP should be minimized, since they act as stress concentrators for each of the as-grown grains.
Soda-lime glass is the preferred composition for the bonding layer of modern columnar TBCs.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

You know the right answer?

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet...