Engineering, 07.05.2021 02:30 arivalen

A cyclic tensile load ranging from 0 kN to 55 kN force is applied along the length of a 100 mm long bar with a 15 mm x 15 mm square cross section. The bar is made of a 7075-T6 aluminum alloy which has a yield strength of 500 MPa, a tensile strength of 575 MPa, and a fracture toughness of 27.5 MPaâm. Required:
a. What is the nominal maximum tensile stress on the bar?
b. If there were an initial 1.2 mm deep surface crack on the right surface of the bar, what would the critical stress needed to cause instantaneous fast fracture of the bar be?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 19:20, diawia

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

continue

Engineering, 04.07.2019 19:20, brae72

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

continue

You know the right answer?

A cyclic tensile load ranging from 0 kN to 55 kN force is applied along the length of a 100 mm long...