Engineering, 05.05.2021 17:40 TimaGarcia

Functionally graded materials are intentionally fabricated to establish a spatial distribution of properties in the final product. Consider an L × L two-dimensional object with L = 20 mm. The thermal conductivity distribution of the functionally graded material is k(x) = 25 W/m·K +(9010 W/m5/2·K) x3/2. Two sets of boundary conditions, denoted as cases 1 and 2, are applied. (a) Determine the spatially averaged value of the thermal conductivity k¯ . Use this value to estimate the heat rate per unit length for cases 1 and 2.
(b) Using a grid spacing of 2 mm, determine the heat rate per unit depth for case 1.
(c) Using a grid spacing of 2 mm, determine the heat rate per unit depth for case 2.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, shayshay7874

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

continue

You know the right answer?

Functionally graded materials are intentionally fabricated to establish a spatial distribution of pr...